Solar and battery installation in Greystanes

The Greystanes record runs from 6.6kW to 29kW, the widest spread on this site, and includes a 51.2kWh battery. Understanding why explains more than any average would.

Solar in Greystanes: 6.6kW to 29kW on three houses

Greystanes accounts for three completed Crown Solar installations, and all three carry a recorded system size: 6.6kW, 15.0kW and 29.0kW. One of them also carries a battery of 51.2kWh, among the largest Crown Solar has installed anywhere.

That is a spread of more than four to one across three houses in one suburb, and it is the widest range on this site. An average of those three figures would be nonsense. It would describe none of them. So instead of publishing one, this page explains what moves a residential system from one end of that range to the other, because that is the question you are actually asking.

Greystanes sits in the Cumberland City Council area on postcode 2145, which it shares with a number of neighbouring suburbs, and it runs up against Prospect Reservoir on its western edge.

3completed Crown Solar installations in Greystanes
February 2027Endeavour's published phase for postcode 2145, month only

What moves a house from 6.6kW to 29kW

Four things, roughly in order of how much they matter.

Supply arrangement. A single-phase house has a practical ceiling well below 29kW. Above roughly 10kW of inverter capacity three-phase supply is usually the requirement, and it also changes which inverters are suitable and how a battery is configured. This is the first thing established on any Greystanes quote, before a design is drawn, because everything else follows from it.

What is on the meter. A second dwelling, a granny flat or secondary dwelling sharing the supply, raises both daytime and overnight consumption substantially, and is one common explanation for a large residential system in this part of Sydney. So is electric hot water, ducted air conditioning, a pool, or one or two electric vehicles. If any of those apply, or will within a couple of years, they belong in the sizing conversation now rather than as a later regret.

Usable roof. The north and west faces that can actually carry panels are routinely about half of what the roof looks like from the street. On a house with a hip roof divided into four modest faces, the roof sets the ceiling long before the budget does, and no amount of consumption changes that.

What you can do with the surplus. Until flexible exports reach 2145, a fixed export limit applies, so generation you can neither use nor export is generation you paid for once and will never see. That is the arithmetic that makes a 6.6kW system on a modest household a perfectly sound purchase, and makes storage worth considering before another array expansion.

Your grid connection: Endeavour Energy, postcode 2145

Greystanes is in the Endeavour Energy distribution area. Endeavour approves the connection and sets the export limit. Your electricity retailer does neither.

Where 2145 sits in Endeavour's rollout

Endeavour stages flexible exports by postcode, not by council.

  1. Stage 1, commenced 2 November 2026 Postcodes in and around the Campbelltown, Camden, Picton and Liverpool regions.
  2. Stage 2, commences 30 November 2026 A further set of postcodes across Endeavour's area.
  3. Phase 3, February 2027 Endeavour has published the month and not a day within it. Its rollout map gives the date for a specific address. Postcode 2145 is in this stage

What you may export, by connection type

Endeavour Energy, kilowatts per phase.

Export allowance by connection type A flexible export connection allows up to 10kW per phase most of the time. The Fixed Exports opt-out allows a maximum of 1.5kW. Flexible export 10kW Fixed export 1.5kW
A flexible export connection allows up to 10kW per phase, most of the time. The network reduces that only when local grid conditions require it. The Fixed Exports opt-out allows a maximum of 1.5kW. Both carry the same connection requirements.

Flexible exports reach 2145 in the February 2027 phase

Endeavour has published two rollout stages by postcode. The first commenced on 2 November 2026, covering postcodes in and around the Campbelltown, Camden, Picton and Liverpool regions. The second commences on 30 November 2026 and adds a long list of Blue Mountains, Penrith, Hawkesbury and Illawarra postcodes. 2145 appears in neither, which places Greystanes in the February 2027 phase of Endeavour's availability plan. Endeavour has published the month, not a date within it, so this page gives the month and nothing more precise. Treat any quote that names a specific February day for 2145 as unsourced.

When it applies, a flexible export connection allows up to 10kW per phase to be exported most of the time, reduced only when local grid conditions require it. The opt-out is Endeavour's Fixed Exports plan with a maximum export of 1.5kW.

On a large system the per-phase basis is the whole arithmetic. Ten kilowatts per phase on three phases is a different proposition from ten kilowatts on one, and it is a substantial part of why a 29kW array can make sense on a residential block at all.

What your system has to meet

Endeavour requires an address in its network area, an active internet connection by Wi-Fi or cable, net export metering configured for the solar inverter, and a CSIP-AUS approved inverter listed on the Clean Energy Council website.

Larger systems carry a further consideration. Streamlined approval pathways apply up to certain inverter capacity thresholds, and above those a proposal can require a more detailed network assessment, which takes longer and may carry a cost. At the top of the range recorded locally that is a live question rather than a footnote, and the timeline belongs in the plan from the start.

The emergency backstop mechanism allows the network to curtail exports when the grid cannot absorb what is being sent into it. Endeavour describes it as a last resort, expected to be used rarely and for short periods.

What Greystanes properties mean for system design

Housing spans several decades, so nothing here is predictable. Unlike a single-era estate, Greystanes carries post-war housing, later infill and more recent rebuilds, sometimes on one street. Roof material, roof age and switchboard condition therefore have to be established property by property rather than inferred from the suburb.

Rooftop solar panels on a home in New South Wales
Illustrative. The usable north and west area is normally smaller than the roof looks from the street.

Switchboard age is the recurring cost. On the older stock a board frequently needs replacement or upgrade before a battery, in capacity, protective devices and physical space. On a large system it also has to accommodate more protection than a modest one. It is assessed and priced before you sign rather than raised on installation day.

Asbestos in a pre-1990 house is a constraint to plan for. Bonded asbestos cement sheeting was used in Australian housing until the late 1980s, including eaves linings and meter box backing boards. Where it is present it changes how cable is run and who may do that work. It does not prevent an installation; it means the eaves and meter box are inspected during the assessment rather than discovered with a drill.

Roof condition decides the sequence. Where a tile roof is at or past its maintenance interval, doing that work after an array is installed means paying to remove and refit the array. The roof is assessed at quote stage so the order of work is a decision rather than a surprise.

Heat, because this is western Sydney. Panels are rated at a cell temperature of 25°C and output falls as the cell rises above it, and inverters reduce their own output when they overheat. So the inverter position is a design decision: out of direct afternoon sun, with airflow around it, and not boxed into an unventilated cupboard.

Winter shading from mature planting. A tree that casts nothing on the roof in January can cover a significant part of an array at nine in the morning in June, because the sun is roughly thirty degrees lower. Shading is assessed for the winter sun path rather than from how the roof looks on the day of the visit.

Reading that 51.2kWh battery properly

It is the largest figure on the local record and the easiest one to misread, so here is what it is and is not.

It is not a target. A battery is sized against evening and overnight consumption, not against the size of the array and not against what a neighbour has. A 51.2kWh battery belongs with a large array and a large, genuinely after-dark load. On an average household it would spend most of its life partly full, which is an expensive way to own a battery.

A smaller battery that is actually cycled every day is a better outcome than a large one that is rarely emptied. That holds at every size, and it is the single most useful sentence about storage on this site.

What justifies real capacity is a measured overnight figure: electric hot water on a timer, ducted air conditioning running into the night, a second dwelling, or a household that is genuinely awake and consuming after dark. Your interval data settles it. Many retailers provide it on request or through an online portal, and a smart meter makes the daytime and after-dark split precise rather than estimated.

Where a battery is being retrofitted, the inverter decides most of the cost. Adding storage is treated as an upgrade, which brings the connection under current requirements, so an inverter that is not CSIP-AUS approved turns an addition into a replacement plus an addition.

The federal battery discount is applied by the installer at the point of sale through the small-scale certificate mechanism, and the rate steps down over time. Crown Solar sets out the figure applying to your quote in writing rather than publishing one here.

Approvals: Cumberland City Council and the NSW planning rules

Greystanes falls within Cumberland City Council. For most rooftop installations the council is not the approval authority, because most rooftop solar in NSW is exempt development under State Environmental Planning Policy (Transport and Infrastructure) 2021 and requires no development application.

The exemption is conditional, and on a large system the condition that matters most is the capacity limit: a system well above ordinary residential scale can fall outside the exemption and require development consent, which is a different timeline and cost. The exemption also carries a restriction on panels facing the street and limits on land with heritage significance, and Cumberland maintains a heritage schedule. For lots toward the creek lines through this part of the council area the flood position is worth establishing as well, since it bears on where ground-level equipment can safely be sited. Crown Solar checks the lot and the proposal before the quote is finalised.

What the installation actually involves

  1. Supply arrangement first. Single or three phase, and whether any second dwelling shares the meter, because together they set the ceiling.

  2. Twelve months of consumption. Bills and, where available, interval data split between daytime and after dark, because the array and the battery are sized from different halves of it.

  3. Site assessment. Roof material, pitch, age and condition, usable faces, winter shading, and the inverter position chosen for temperature as well as cable run.

  4. Switchboard, meter box and eaves. Capacity and space for a system of the proposed size, and whether pre-1990 sheeting is present.

  5. Approval pathway. Whether the proposal stays inside exempt development, and which Endeavour assessment pathway the inverter capacity triggers.

  6. Design and quote. Array and battery sized separately and stated separately, with the reasoning shown, and the export arrangement that applies given the February 2027 phase.

  7. Connection application to Endeavour Energy. Nothing is installed before approval.

  8. Commissioning, metering and handover paperwork.

Find out what your roof can carry

The design starts with your roof and your own bill, not with a number over the phone.

Crown Solar does not quote off a template or over the phone. Every design is built on your own site data.

Common questions about solar in Greystanes

Should I wait for February 2027?

Generally not. Most of the value of a solar system is in the energy you use yourself rather than the energy you export, and in this climate self-consumption is high because the cooling load runs when the sun is up. What you should insist on is the arrangement being stated in writing on the quote.

My neighbour has 29kW and I was quoted 6.6kW. Has someone made a mistake?

Probably not. Those are both real Greystanes systems. The difference is supply arrangement, what is on the meter, and usable roof, not ambition. Ask your installer to show which of the three is limiting you, because that is a checkable answer.

What should I ask every installer who quotes me?

Whether the supply is single or three phase and whether any upgrade is included, what daytime and overnight figures the array and battery were sized from, whether the switchboard and roof have been inspected and priced or merely assumed, and what export arrangement applies in writing.

What Crown Solar installs here

The panel Crown Solar is currently installing is Trina Solar, fitted as the high-wattage Vertex range. On the local record Jinko Solar, LONGi and Canadian Solar panels all appear on Greystanes roofs from the earlier years of this work. Three jobs and three different panels, which is what happens when work is spread over several years in a market that changes its product line annually. The panel on your quote is the current one, not the one on a neighbour's roof. Crown Solar also installs JA Solar, AE Solar and LONGi panels.

Inverters and storage

GoodWe accounts for most of the recorded inverters on the Greystanes jobs.

Crown Solar also installs FoxESS, Sungrow, Fronius and SAJ inverters, and Tesla Powerwall, Sigenergy and AlphaESS batteries. On a large or three-phase system the choice is narrowed first by capacity and by what you need backed up, and only then by preference, so it is made with the design rather than before it. Those are the current range, available on any job, not a list of what has been fitted locally.

Talk to Crown Solar about your Greystanes home

Crown Solar is a NSW electrical contractor, licence 378172C, and a New Energy Tech Approved Seller. The office is at 3B/4 Louise Avenue, Ingleburn, and is open Mon–Fri 9am–5pm.

For a quote on a Greystanes address, call 1800 38 50 38, email info@crownsolar.com.au, or use the contact form.

Get it in writing for your Greystanes address

Send the address and your last four quarterly bills. You get a system size, the roof faces it sits on, the export arrangement, and the price. All in writing.

Prefer email? info@crownsolar.com.au. One question to start with: what is your place using in a quarter?

Want this checked against your own roof and bill?

Get a free, no-obligation quote